vfs: Force boot interface FW using start_if.act#1079
Open
imi415 wants to merge 1 commit intoARMmbed:mainfrom
Open
vfs: Force boot interface FW using start_if.act#1079imi415 wants to merge 1 commit intoARMmbed:mainfrom
imi415 wants to merge 1 commit intoARMmbed:mainfrom
Conversation
The current behavior of the start_if.act is resetting to the bootloader and assuming the bootloader will jump to the interface firmware, without doing anything specific. On certain targets (like Kinetis), the RST signal may be held down by the target due to buggy program being downloaded to the target, causing the probe enters bootloader mode in such condition. This patch adds another settings entry which will be set by the MSD command, and will temporarily make the bootloader ignoring the state of the RST pin, force starting the interface firmware. Signed-off-by: Yilin Sun <imi415@imi.moe>
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
1 participant
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
The current behavior of the start_if.act is resetting to the bootloader and assuming the bootloader will jump to the interface firmware, without doing anything specific. On certain targets (like Kinetis), the RST signal may be held down by the target due to buggy program being downloaded to the target, causing the probe enters bootloader mode in such condition.
This patch adds another settings entry which will be set by the MSD command, and will temporarily make the bootloader ignoring the state of the RST pin, force starting the interface firmware.